Cart 2 india

Specification
Brand : Garosa
BulletPoint1 : The module is to convert frequency pulseof 0-5 KHz into an analog voltageof 0-10V.
BulletPoint2 : The multi-coil potentiometer on the board is used to calibrate the corresponding relationship between frequency and voltage.
BulletPoint3 : The optical isolate is used in the input end of theto ensure the anti-interference ability.
BulletPoint4 : The input pulse level of 5V 12V 24V and can be directly input without string resistor. But the inputfrequency should be maintained for more than 0.5 seconds, and the output current is 5mA.
BulletPoint5 : The converter can be used for interface conversion between PLC and inverter or interface matching control between motion control card and inverter.
BulletPoint6 : This shop has various kinds of goods and good quality. Please rest assured. We offer you quality pre sales and after service.
Color : #126
IncludedComponents : No
ItemName : Digital to Analog Module, Frequency Voltage Converter Module 0-5KHz to 0-10V, Industrial PLC Inverter Motion Control Interface, Power Converters
ItemPackageDimensions_Height : 3 centimeters
ItemPackageDimensions_Length : 12 centimeters
ItemPackageDimensions_Width : 9 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : frequency-transducers
Manufacturer : Garosa
Material : copper
MaximumSupplyVoltage : 10 volts
ModelName : Genericvaz4n0yeh9
ModelNumber : Garosac2hq45r7gg
NumberOfBoxes : 1
NumberOfItems : 1
PartNumber : Garosac2hq45r7gg
ProductDescription : Specification:
Item Type:Frequency to Voltage Converter Module
Size:4.5 x 4.7 x 1.7cm / 1.77 x 1.85 x 0.67in
Relationship,Linearity:
500Hz to 1V
2.5Khz to 5V
5Khz to 10V
Package List:
1 x FV-5KHz10V Frequency to Voltage Converter Module

Note:
For use with PLC, support for NPN type. Must have a ground wire.
If you need to use an encoder, you need to keep the encoder running at a constant speed for more than 0.5 seconds.
Frequency and voltage conversion module, response time is about 0.3-0.5 seconds.
If theinput isflow, etc., due tomatching, an 817 diaphragm and a resistor must be added to match the flowmeter to function properly.
If there is a deviation in the correspondence when using, you can adjust the blue potentiometer on the board to calibrate. At the time of shipment, we have adjusted the F/V potentiometer to a certain correspondence. It is generally not recommended to adjust it by itself.
Input power supply voltage range is 12-30 VDC, recommended supply voltage 15-24 VDC.When at 12V level, the power supply can not use 12VDC power supply, at least 15 VDC power supply, if a certain need to use 12V power supply, can also be customized 12VDC power supply converter. When at 24V level, the power supply need to use 24VDC power supply.

ProductSiteLaunchDate : 2024-06-17T14:24:42.130Z
Size : One Size
UnitCount : 1
UnspscCode : 52161500
WarrantyDescription : Manufacturer warranty for 90 day
Wattage : -0.01 milliamp_hours