Cart 2 india

Specification
Brand : Aqur2020
BulletPoint : POTTER ELECTRIC SIGNAL POTTER VSR-4 WATERFLOW SWITCH 4"VANE TYPE WITH RETARD
BulletPoint1 : The switch is usually used in places where interlocking or
BulletPoint2 : brand new and high quality
BulletPoint3 : STFS-25 fully sealed liquid switch can use different slurry according to the rate of installed pipeline.
BulletPoint4 : When the liquid exceeds or falls below the set rate, its single-pole double-throw switch (SPDT) can make one circuit conduct, while cutting off the other circuit.
BulletPoint5 : Used for sensing changes rate of liquids flowing through pipes, such as water, ethylene, or other non-hazardous liquids.
ExternallyAssignedProductIdentifier : 9130969714227
ExternallyAssignedProductIdentifier1 : 0785192012825
ExternallyAssignedProductIdentifier2 : 785192012825
IncludedComponents : inc
ItemName : Liquid Temperature () : -25-120 Water Controller Water Switch 6-380V Sensing Changes for Mechanical Adjustment Pipe Fittings
ItemPackageDimensions_Height : 7 centimeters
ItemPackageDimensions_Length : 20 centimeters
ItemPackageDimensions_Width : 10 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : industrial-flow-switches
Manufacturer : Aqur2020
Material : Material
NumberOfItems : 1
PartNumber : Aqur2020qtkxnph4ie4924
ProductDescription : Features:

brand new and high quality
Used for sensing changes rate of liquids flowing through pipes, such as water, ethylene, or other non-hazardous liquids.
When the liquid exceeds or falls below the set rate, its single-pole double-throw switch (SPDT) can make one circuit conduct, while cutting off the other circuit.
The switch is usually used in places where interlocking or "cut-off" is required.
STFS-25 fully sealed liquid switch can use different slurry according to the rate of installed pipeline.


Specification:
Wide voltage:6-380V

Pipe fittings: 1" 11-1/2NPT
Material of bellows and blades: phosphorous bronze and stainless steel
Blade: 1", 2", 3 ", 6"
Liquid temperature () : -25-120
Maximum liquid pressure: (bar) : 15
 
Installation and adjustment:
1. Open the switch housing;
2. The switch has been set at the minimum value when leaving the factory. Increase the setting value and turn the adjusting screw clockwise;
3. Press the target piece to check whether the micro switch can work normally. Excessive counterclockwise rotation of the adjustment screw may to the failure of the switch;
4. After the installation, please press the switch to check the pulp bar several times. One day, there is no "click" sound when the pulp bar returns.Turn adjusting screw clockwise until there is a "click" sound;
5.  The adjustment screw of black lacquer seal is only for factory to adjust the switch state, please do not change or adjust it;
6. Observe three working cycles, make sure that the switch and the system connected with it are in normal operation, and cover the switch shell in time.
 
Package list:
1




ProductSiteLaunchDate : 2021-06-22T00:00:00.000Z
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1
UnspscCode : 39122200