Cart 2 india

Specification
Brand : Gems
BulletPoint : POTTER ELECTRIC SIGNAL POTTER VSR-4 WATERFLOW SWITCH 4"VANE TYPE WITH RETARD
BulletPoint1 : Product Type :Electronic Switch
BulletPoint2 : Package Dimensions :11.43 Cm L X 6.604 Cm W X 5.334 Cm H
BulletPoint3 : Country Of Origin :United States
BulletPoint4 : Package Weight :1.0Lbs
BulletPoint5 : Used for sensing changes rate of liquids flowing through pipes, such as water, ethylene, or other non-hazardous liquids.
ConnectivityProtocol : Din
ConnectorType : 1/4" Mnpt
ExternallyAssignedProductIdentifier : 9130969714227
ExternallyAssignedProductIdentifier1 : 0785192012825
ExternallyAssignedProductIdentifier2 : 785192012825
IncludedComponents : inc
InternationalProtectionRating : IP41
ItemName : Gems PS41-20-4MNB-C-HC Series PS41 Economical Miniature Pressure Switch, SPDT Circuit, DIN 43650A 9 mm Cable Clamp, 7-30 psi Range, 1/4" MNPT Brass Fitting
ItemPackageDimensions_Height : 5.334 centimeters
ItemPackageDimensions_Length : 11.43 centimeters
ItemPackageDimensions_Width : 6.604 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : industrial-flow-switches
Manufacturer : Gems Sensors, Inc.
Material : Brass
ModelNumber : 209018
MountingType : DIN Rail Mount
NumberOfItems : 1
PartNumber : PS41-20-4MNB-C-HC
ProductDescription : Features:

brand new and high quality
Used for sensing changes rate of liquids flowing through pipes, such as water, ethylene, or other non-hazardous liquids.
When the liquid exceeds or falls below the set rate, its single-pole double-throw switch (SPDT) can make one circuit conduct, while cutting off the other circuit.
The switch is usually used in places where interlocking or "cut-off" is required.
STFS-25 fully sealed liquid switch can use different slurry according to the rate of installed pipeline.


Specification:
Wide voltage:6-380V

Pipe fittings: 1" 11-1/2NPT
Material of bellows and blades: phosphorous bronze and stainless steel
Blade: 1", 2", 3 ", 6"
Liquid temperature () : -25-120
Maximum liquid pressure: (bar) : 15
 
Installation and adjustment:
1. Open the switch housing;
2. The switch has been set at the minimum value when leaving the factory. Increase the setting value and turn the adjusting screw clockwise;
3. Press the target piece to check whether the micro switch can work normally. Excessive counterclockwise rotation of the adjustment screw may to the failure of the switch;
4. After the installation, please press the switch to check the pulp bar several times. One day, there is no "click" sound when the pulp bar returns.Turn adjusting screw clockwise until there is a "click" sound;
5.  The adjustment screw of black lacquer seal is only for factory to adjust the switch state, please do not change or adjust it;
6. Observe three working cycles, make sure that the switch and the system connected with it are in normal operation, and cover the switch shell in time.
 
Package list:
1




ProductSiteLaunchDate : 2012-10-03T00:00:01-07:00
SpecificationMet : Ce (Ul Available)
SupplierDeclaredDgHzRegulation : unknown
SwitchType : Pressure Switch
TerminalType : Spdt
UnitCount : 1
UnspscCode : 39121705
UpperTemperatureRating : 185 degrees_fahrenheit