Specification Brand : XISAOK BulletPoint1 : BulletPoint2 : BulletPoint3 : BulletPoint4 : BulletPoint5 : Color : As picture shown ExternallyAssignedProductIdentifier : 7552960128162 ItemName : 4 Points Hall Effect Flow Sensor Flowmeter 1-25L/Min Water Flow Sensor ItemPackageDimensions_Height : 20 centimeters ItemPackageDimensions_Length : 10 centimeters ItemPackageDimensions_Width : 8 centimeters ItemPackageQuantity : 1 ItemTypeKeyword : electronic-component-flow-sensors Manufacturer : XISAOK Material : brass NumberOfItems : 4 PartNumber : XISAOK ProductDescription : Features: To prevent particles and sundries from entering the sensor, a filter screen must be installed at the sensor inlet. The water flow sensor shall be installed inside the equipment indoors, and shall not be exposed outdoors wet for a long time-under high temperature and other harsh environments, the installation of water flow sensor must avoid the environment and application of vibration and shaking so as not to affect the measurement accuracy of the When the magnetic material the material that generates magnetic force to the sensor close to the sensor, its characteristics may occur change. Do not disassemble the water flow sensor without authorization to prevent damage. Any water flow sensor disassembled without authorization not in the scope of-warranty. This structural sensor has not been used, and there may be discomfort when used for direct replacement, please put forward.
Specifications: Interface Size: 4 points (G1/2) Working Voltage: DC3.5-24V Outer Diameter: 20.3mm Thread Length: 11mm Brass Water Pressure Resistance: ≤1.75MPa Output Pulse: High Level>DC4.7V (input voltage DC5V) Output Pulse: Duty Cycle 50%±10% Flow Range: within 1-25LIMIT±3% Working Water Flow Range: 1-25L/MIN±3% Flow-Pulse Characteristic: 11x0) 〇=L/Min±3% Size: Approx. 2.2x6.6cm/0.87x2.60in
Note: Severe and chemical-erosion are strictly prohibited. Strictly prohibited to throw, move collision. Vertical installation, with a of no more than 5°. The medium temperature should not exceed 120℃.
Wire Method: IN to positive Yellow OUT signal output line. Black GND connect to negative