Cart 2 india

Specification
Brand : DSNMYO
BulletPoint : Valves
BulletPoint1 : ❀Made of high quality ABS and metal it is solid, stable and good performance, serve you for a long for time.
BulletPoint2 : ❀0.3-10L/min, high efficiency, stable performance.
BulletPoint3 : ❀G 1/4" fast connection interface, easy to install.
BulletPoint4 : ❀Suitable for water dispenser, water heater and so on.
BulletPoint5 : ❀Water flow sensor only, other accessories demo in the picture is not included!
Color : USN-HS08PA-4
Department : Unisex Adult
ExternallyAssignedProductIdentifier : 7320437429926
ItemName : 10pcs/lot Water Flow Sensors 1.8-5.5V USN-HS08PA 8-10mm Hose Barb End 1% Repeat Error for Drinking Water Heater Coffee(USN-HS08PA-4)
ItemPackageDimensions_Height : 1 centimeters
ItemPackageDimensions_Length : 3 centimeters
ItemPackageDimensions_Width : 2 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : electronic-component-flow-sensors
Manufacturer : DSNMYO
Material : ABS&Metal
ModelName : DSNMYO
ModelNumber : DSNMYO
NumberOfBoxes : 1
NumberOfItems : 1
PartNumber : DSNMYO
ProductDescription : Valves
Model:USN-HS08PA
Features:
1.Food grade POM (polyformaldehyde) material, environmental friendly material, small, flexible and functional.
2.Intubation design of inlet and outlet pipe, easy connection and operation;
3.Imported Hall IC from , stable and reliable;
4. FlowRange: see above
5.Working voltage: DC1.8-5.5V is available against request.
6.Rated voltage and current: DC5V; no more than 10A.
7.Output voltage(rated: DC 5V); High level 4.5V and above; low level 0.5V and below
8.Pulse output duty cycle: 50+-10%
9.Insulation resistance: 100M Ohm and above;
10. Tightness: Seal up all the holes, and inflate with 0.8MPa water, after 1 minute, no leakage and deformation;
11. -20-60 centigrade;
12. Working Pressure: under 0.8Mpa;
13. Electrical Strength: AC500V 50Hz.
14. Wire length: regular 32cm, other length can be tailor made against request.
15. End connection: SM2.54 .
Note:
1. When magnetic material is close with the sensor,its characteristics may vary.
2. In order to avoid particle debris, the sensor must beinstalled after a filter.
3. The flow sensor installation has to avoid strong vibration and shaking of the environment, so as not to affect the sensor's measurement accuracy.
ProductSiteLaunchDate : 2024-08-03T05:50:49.003Z
Size : One Size
UnitCount : 1