Cart 2 india

Specification
Brand : GS Tooling
BulletPoint : CAT40 C 1-1/4-4
BulletPoint1 : Shank Type: Taper Shank
BulletPoint2 : Taper Size: CAT50
BulletPoint3 : Used for layout, set-up, checking heights, depths and setting angles
BulletPoint4 : Projection (mm): 80
BulletPoint5 : Nose Diameter (mm): 24
Color : As Shown
ExternallyAssignedProductIdentifier1 : 0752273562111
ExternallyAssignedProductIdentifier2 : 752273562111
FinishType : Chrome
IncludedComponents : Doweling Jig
ItemName : GS Tooling 541908 CAT50 10mm x 80mm Shrink Fit Holder with Coolant Ports
ItemPackageDimensions_Height : 9.25 inches
ItemPackageDimensions_Length : 4.43 inches
ItemPackageDimensions_Width : 4.43 inches
ItemPackageQuantity : 1
ItemTypeKeyword : end-mill-holders
Manufacturer : GS Tooling
Material : Alloy Steel
ModelName : Jectse9uq2kg7cps-11
ModelNumber : 51G2M564409NL
NumberOfItems : 1
PartNumber : 541908
ProductDescription : Shank Type: Taper Shank
Taper Size: CAT50
Hole Diameter (mm): 10
Projection (mm): 80
Nose Diameter (mm): 24
Through Coolant: Yes
Unsurpassed Accuracy: Concentricity of ?0.0001" (3µm) with tool shrunk in holder. Coolant Ports: Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool. Max Gripping Torque: Tool is gripped 360º along the entire length of bore producing very high gripping torque, preventing chatter. Increased Production: Decrease down time - the total time elapsed to remove one cutting tool and insert another is less than 10 seconds. Balanced: GS follows the strictest balance standards. Our holders are pre-balanced G2.5 up to 30,000rpm Extended Holder Life: With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS Shrink Fit Toolholder should far outlast a standard end mill holder. Chip load distributed evenly along cutting edge of tool which results in longer tool life Short projections are possible because no mechanical clamping devices are used. This results in greater rigidity and resistance to bending. Since Shrink Fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market
ProductSiteLaunchDate : 2023-06-20T14:02:54.726Z
Size : 7X5.7cm
Style : centimeter
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1
UnspscCode : 27112803
Voltage : 970 volts