Cart 2 india

Specification
Brand : Simpson Strong-Tie
BulletPoint1 : 1/4-inch by 3-1/2-inch
BulletPoint2 : 1/4-inch Drill Bit Diameter
BulletPoint3 : Heat-Treated Carbon Steel
BulletPoint4 : Zinc Plated
BulletPoint5 : NUTS AND WASHERS INCLUDED-Ready to install; simple and fast
ExteriorFinish : Yellow Zinc
ExternallyAssignedProductIdentifier1 : 044315909818
ExternallyAssignedProductIdentifier2 : 0044315909818
ExternallyAssignedProductIdentifier3 : 00044315909818
IncludedComponents : Hardware
ItemName : Simpson Strong Tie CSD25312 Simpson Strong-Tie Countersunk Head Zinc Plated Split Drive Anchor 1/4-inch by 3-1/2-inch 100 per Box
ItemPackageDimensions_Height : 9.398 centimeters
ItemPackageDimensions_Length : 19.812 centimeters
ItemPackageDimensions_Width : 9.652 centimeters
ItemPackageQuantity : 1
ItemShape : Block
ItemTypeKeyword : drive-anchors
ItemTypeName : Simpson Strong Tie Simpson Strong-Tie CSD25312 Countersunk Head Zinc Plated Split Drive Anchor 1/4-inch by 3-1/2-inch 100 per Box
Manufacturer : Simpson Strong Tie
ManufacturerGrade : Grade 2
Material : Alloy Steel
Material1 : carbon_steel
Material2 : zinc plated
Material3 : Carbon Steel Yellow Zinc
Material4 : Carbon Steel Yellow Zinc
Material5 : Carbon Steel Yellow Zinc
MaximumShearStrength : 10125
MeasurementSystem : Inch
ModelName : Simpson Strong-Tie
ModelNumber : CSD25312
NumberOfBoxes : 1
NumberOfItems : 1
NumberOfPieces : 15
PartNumber : CSD25312
ProductDescription : Applications
The anchor is made from Carbon Steel, and is Yellow Zinc. This anchor is designed for use in Concrete only, and should never be used in block or brick base material.

Environment
The anchor is designed for use in a Dry environment.

Hole Diameter/Bit Diameter
The anchor requires a 3/4" hole to be drilled in the base material (Concrete only). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.

Diameter of Anchor
The diameter of the anchor is 3/4".

Length Anchor
The length of the anchor is 6"
Minimum Embedment
The minimum anchor embedment into the concrete is 3". Therefore, the anchor must be installed so that a minimum of 3" of the anchor is embedded into the concrete.

Maximum Fixture Thickness
The maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 2-1/4". This will ensure that the minimum embedment of 3" will be met.

Fixture Hole Diameter
The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 3/4" diameter anchor requires the hole in the fixture to be 7/8".

Spacing between Anchors
Each anchor must be spaced a minimum distance of 7-1/2" from each other when measured center to center.

Edge Distance
It is very important not to install the anchor any closer than 3-3/4" from an unsupported edge of the concrete.
ProductSiteLaunchDate : 2013-12-09T00:00:01-08:00
Size : One Size
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1