Cart 2 india

Specification
Brand : CONFAST
BulletPoint1 : INSTALLS INTO A VARIETY OF BASE MATERIALS-Can be used in a variety of applications making job easier and faster
BulletPoint2 : ANCHOR DIAMETER EQUALS HOLE DIAMETER-Makes it easy to determine hole size
BulletPoint3 : ALL SIZES PACKAGED 100 PIECES PER BOX-Quantity makes it easier to purchase and use
BulletPoint4 : PERMANENT FASTENING-Once installed, fastener cannot be removed, very secure
BulletPoint5 : NUTS AND WASHERS INCLUDED-Ready to install; simple and fast
Color : Silver
ExteriorFinish : Yellow Zinc
ExternallyAssignedProductIdentifier1 : 044315909818
ExternallyAssignedProductIdentifier2 : 0044315909818
ExternallyAssignedProductIdentifier3 : 00044315909818
IncludedComponents : Hardware
ItemName : CONFAST 1/4" x 1" Stainless Steel Hammer Drive Nail in Anchor (100 per Box)
ItemPackageDimensions_Height : 2.5 inches
ItemPackageDimensions_Length : 4 inches
ItemPackageDimensions_Width : 3.5 inches
ItemPackageQuantity : 1
ItemShape : Block
ItemTypeKeyword : drive-anchors
ItemTypeName : Simpson Strong Tie Simpson Strong-Tie CSD25312 Countersunk Head Zinc Plated Split Drive Anchor 1/4-inch by 3-1/2-inch 100 per Box
Manufacturer : CONFAST
ManufacturerGrade : Grade 2
Material : Zamac body - 304 Stainless steel nail
Material1 : Carbon Steel
Material2 : Zinc
Material3 : Carbon Steel Yellow Zinc
Material4 : Carbon Steel Yellow Zinc
Material5 : Carbon Steel Yellow Zinc
MaximumShearStrength : 450
MeasurementSystem : Inch
ModelName : Simpson Strong-Tie
ModelNumber : CSD25312
NumberOfBoxes : 1
NumberOfItems : 100
NumberOfPieces : 100
PartNumber : HDS141
ProductDescription : Applications
The anchor is made from Zamac body - 304 Stainless steel nail. This anchor is designed for use in Concrete, Block, and Brick.

Environment
The anchor is designed for use in a Wet environment.

Hole Diameter/Bit Diameter
The anchor requires a 1/4" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.

Diameter of Anchor
The diameter of the anchor is 1/4".

Length Anchor
The length of the anchor is 1"
Minimum Embedment
The minimum anchor embedment into the concrete is 3/4". Therefore, the anchor must be installed so that a minimum of 3/4" of the anchor is embedded into the concrete.

Spacing between Anchors
Each anchor must be spaced a minimum distance of 2-1/2" from each other when measured center to center.

Edge Distance
It is very important not to install the anchor any closer than 1-1/4" from an unsupported edge of the concrete.
ProductSiteLaunchDate : 2017-06-09T10:38:08.606Z
Size : One Size
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1