Rose Pure Dew Refining
1. Prepare 100g/3.5oz of rose petals and 200ml/6.76oz of water ( if you want to extract more concentrated dew, you can add more petals with less water), then put it into a container, add a little salt, and stir them.
2. Use a match (not included) to light the alcohol lamp and wait a few minutes (the alcohol lamp will heat more slowly) for the water to boil and the roses to lighten in color.
3. Distillation of steam into the condenser tube tail pipe outflow, pure dew production success.
Essential Oil Refining
1. Check if the funnel is leaking.
2. Pour the mixed liquid into the funnel, place the funnel on the iron ring and let it stand.
3. Open the piston of the separating funnel, then open the cork so that the lower liquid (water) is released from the lower end of the separating funnel, and close the cork when the oil-water interface is tangent to the top of the cork.
4. Use the glass dropper to remove the essential oil.
Specification
Color: Clear
Flask Capacity: 500ml/16.9OZ
Assembly Required: Yes
Material: High Borosilicate Glass, Iron, Rubber, Latex
Conical Flask, Funnel, and Beaker Capacity: 100ml/3.38OZ
High-temperature Resistant: Less Than 350℃/662℉
Gross Weight: 3.2kg/7lbs
Net Weight: 2.8kg/6.2lbs
Latex Pipe Length: 1.5m/5FT
Package Size: 43.5*32*22.5cm/17.13*12.6*6.35in
Package Included
1*Serpentine Condenser Tube
1*Pear Shaped Dispensing Funnel
1*Thermometer
1*Cow Horn Tube
1*Beaker
1*Conical Flask
1*Glass Dropper
1*Distillation Flask
1*Iron Stand
2*Essential Oil Bottles
1*Alcohol Lamp
1*Brush
All Accessories Needed for Installation
Notes
1. Before using the product, please fix the base of the iron stand with nuts, then adjust the position of the ten stand and iron clamps, and connect the distillation flask and the condenser tube.
2. The position of the sink should be higher than the plane of the condenser pipe, and then inject about 30ml water from the water inlet pipe with a syringe inside the condenser pipe.
3. Connect the latex tube conduit, and loosen the outlet latex tube stop clip, the water will automatically flow out (siphon phenomenon principle).
4. Please note that the position of the mercury ball in the thermometer should be at the same level as the bottom of the nozzle, and the liquid in the distillation bottle should not exceed 2/3 volume or be less than 1/3 volume.
5. The heating temperature shall not exceed the boiling point of the highest material of the mixture.
6. Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement. Please make sure you do not mind before you order.