Cart 2 india

Specification
Brand : YOUTHINK
BulletPoint1 : COPPER MATERIAL: Solder wick is used to remove and absorb excess solder, copper has oxidation resistance, resistance and good thermal conductivity.
BulletPoint2 : Solder sweeping: The solder wick is made of copper material and special chemicals, which ensures high efficiency, strong removal power, saving time and materials.
BulletPoint3 : 4.9ft Wire Length: The total length of the soldering wire reaches 4.9ft, allowing one coil to last for a long time.
BulletPoint4 : Ensure circuit safety: Solder sucker wire can be used when the pins are connected to tin when soldering components. It will suck the tin that is attached to the pins and prevent short circuits between the pins.
BulletPoint5 : Wide range of applications: Solder wire can also be used to sweeping the pads of BGA components, and if your BGA component is ball-shaped, you can also use the solder wire to sweeping the pads.
ItemName : 2.5mm Wide Wick Copper Material Blade Solder Removal 5 Pieces Solder Wick Copper Width About 2.5mm Length About 1.5m XD-2515
ItemPackageDimensions_Height : 3 centimeters
ItemPackageDimensions_Length : 9 centimeters
ItemPackageDimensions_Width : 7 centimeters
ItemTypeKeyword : desoldering-wicks
Manufacturer : YOUTHINK
ModelName : YOUTHINKq3gcw4u6on
ModelNumber : YOUTHINKq3gcw4u6on
NumberOfItems : 1
PartNumber : YOUTHINKq3gcw4u6on
ProductDescription : Features:
1. Solder Clean: The solder wick is made of copper material and special chemicals, which ensures high efficiency, strong removal power, and saves time and materials.
2. Copper material: The solder wick is used to remove and absorb excess solder. Copper has good oxidation resistance, resistance and thermal conductivity.
5. Wide range of applications: The solder wick can also be used to clean the pads of BGA components. In addition, if the BGA component is ball-shaped, the solder wire can also be used to clean the pads.


How to use:
1. The solder you want to remove is placed on the cleaned reflow point with a suitable length of tin wick, and heated by pressing it lightly with the tip of the electric soldering iron. After the solder , it can be sucked up with the tin wick.
2. After the solder is absorbed, remove the soldering iron and the solder wire at the same time.
3. Cut the used solder wick with scissors. XD-2515
Width: Approx. 2.5mm / 0.1in
Length: Approx. 1.5m / 4.9ft
Working Temperature: Normal Welding












ProductSiteLaunchDate : 2024-07-17T13:29:28.349Z