Cart 2 india

Specification
Brand : RIVERWELD
BulletPoint1 : V-WAC single weld gauge undercuts / pits to 0.240", Crowns to 0.240" by 0.020" Increments Made in Stainless Steel, Markings Inch
BulletPoint2 : Measure pit depth
BulletPoint3 : Measure depth of undercut
BulletPoint4 : Check weld porosity per inch
BulletPoint5 : Check surface porosity size and Measure outside misalignment
Color : Green Type
CustomerPackageType : Standard Packaging
ExternallyAssignedProductIdentifier1 : 720153689241
ExternallyAssignedProductIdentifier2 : 0720153689241
IncludedComponents : Pit Depth Gauge
ItemName : RIVERWELD V-WAC Single Weld Gauge Pit Depth Weld Gage Welding Inspection Thread Gauges Undercuts/Pits to 0.24 Inch by 0.02 Inch Increments
ItemPackageDimensions_Height : 15.1892 centimeters
ItemPackageDimensions_Length : 1.2954 centimeters
ItemPackageDimensions_Width : 9.4996 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : depth-gauges
Manufacturer : RIVERWELDstore
Material : Stainless Steel
ModelNumber : V-WAC
NumberOfBoxes : 1
NumberOfItems : 1
PartNumber : Pit Depth
ProductDescription : The Pit Depth Gauge is a versatile tool that allows you to perform several different types of measurement as well as compare weld defects.

Measure pit depth
Measure depth of undercut
Check weld porosity per inch
Check surface porosity size
Measure outside misalignment

To measure pit depth, lower the gauge to the surface of the material. Gently lower the pointer into and to the bottom of the pit. Read the measurement from this scale.

To measure undercuts, lower the gauge to the surface of the material and gently lower the pointer into the lowest point of the undercut. Again, read the measurement from this scale.

To measure a line surface porosity in one linear inch, place the end of the gauge with the scale along the length of the weld to be examined. Read the amount of aligned pores in one linear inch from the scale with 1/16 of an inch increments.

To compare surface porosity for size, place either the 1/8" or the 1/16" hole in the gauge next to the pore in the weld to be checked. Compare the size of the pores to the holes in the gauge.

To measure outside misalignment, set the bottom of the gauge on one of the pipes, extend the tip of the pointer to the adjacent pipe and move the pointer down to make contact. The reading from this scale will give you the amount of misalignment.


ProductSiteLaunchDate : 2024-09-13T14:00:00.000Z
Size : 3.43 x 1.02inch
Style : Inch 0.24
SupplierDeclaredDgHzRegulation : not_applicable
UnspscCode : 27000000