Cart 2 india

Specification
Brand : WnewTools
BulletPoint1 : K-0609 (low viscosity / general purpose cylindrical parts holding glue) is a one-component, high-strength, general-purpose, low-viscosity anaerobic cylindrical hole/shaft fitting retaining adhesive. The holding glue cures when it is isolated from the air between two closely fitting metals.
BulletPoint2 : Typical use: It is used for the hole/shaft fittings with radial clearance
BulletPoint3 : Typical applications: assembly of new parts bearings, bushings, small motor rotor shafts, bushings, etc.
BulletPoint4 : Specification:
BulletPoint5 : Chemical composition methacrylate
Color : Green
CompatibleMaterial : Leather
ExternallyAssignedProductIdentifier1 : 0769902961610
ExternallyAssignedProductIdentifier2 : 769902961610
ItemForm : Squeeze tube
ItemName : K-0609 Anaerobic Adhesive Seal Glue Cylindrical Fixed Glue Bearing Locking Anti-loose Strong High Temperature Resistance
ItemPackageDimensions_Height : 15 centimeters
ItemPackageDimensions_Length : 22 centimeters
ItemPackageDimensions_Width : 8 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : cyanoacrylate-adhesives
ItemTypeName : K-0609 Anaerobic Adhesive Seal Glue
Manufacturer : Wnew
Material : Plastic
ModelName : K-0609 Anaerobic Adhesive Seal Glue
ModelNumber : PANN1723520
NumberOfBoxes : 1
NumberOfItems : 1
PartNumber : PANN1723520
ProductDescription :

Specification:

Chemical composition methacrylate

Appearance green viscous liquid

Viscosity (25 °C, mPa.s) 100～300

Specific gravity 1.05～1.10

Maximum filling radial clearance (mm) 0.13

Shear strength (MPa) ≥10

Working temperature (°C) -54～149

Initial curing time (minutes) ≤15

Full solid (hours) 24

Instructions for use:

The surface to be coated should be clean, dry and free of grease.

For the sliding fittings, it is only necessary to apply a circle of glue around the shaft and the guide angle of the sleeve, and rotate it to the left and right during assembly to ensure good coating.

For press fit, both quilt bonded surfaces are coated with glue and assembled on a suitable high pressure press.

For heat shrink fittings, the glue should be applied to the shaft and then heated to produce sufficient clearance for free assembly.

Do not tamper with the assembled parts until they have reached sufficient strength.

Precautions for use:

This retaining adhesive should not be used on plastic parts; to avoid contamination of the original glue, do not pour the poured glue back into the original packaging

Safety Precautions:

This retaining gel contains methacrylate and is irritating to the skin and eyes. If the skin comes into contact, immediately wash it with water; if it touches the eyes, rinse immediately with clean water and go to the hospital for treatment.

Package Included:

1 x K-0609 Anaerobic Adhesive Seal Glue

ProductSiteLaunchDate : 2023-11-24T14:53:12.630Z
UnitCount : 1