Cart 2 india

Specification
Amperage : 1 amps
Brand : EC Buying
BulletPoint1 : Double H-bridge, capable of driving two DC motors simultaneously, single circuit 7A current, high power
BulletPoint2 : Wide voltage input DC 6.5V~27V
BulletPoint3 : The signal optocoupler isolates the input and can be directly controlled by the IO port without interference
BulletPoint4 : Under voltage protection to prevent instantaneous high current from burning the module
BulletPoint5 : The high-power TVS and electrostatic discharge circuit suppress transient interference pulses and static electricity, enhance EMC performance
Color : Red
ExternallyAssignedProductIdentifier1 : 0696334086829
ExternallyAssignedProductIdentifier2 : 696334086829
ItemName : EC Buying DC Motor Driver L298 7A 160W Dual H Bridge Motor Speed Controller DC 6.5V-27V PWM Motor Regulator Board 12V 24V Electric Motor Control Module Industrial with Optocoupler Isolation
ItemPackageDimensions_Height : 17.4 centimeters
ItemPackageDimensions_Length : 1.1 centimeters
ItemPackageDimensions_Width : 11.8 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : electric-motor-controls
Manufacturer : EC Buying
Material : Copper
ModelNumber : L298
NumberOfItems : 1
OperatingTemperature : 80 degrees_celsius
PartNumber : L298
PhaseType : Three Phase
ProductDescription : Product parameters:
Working temperature: -25℃~80℃
Product size: 55 * 55 * 16mm/2.17*2.17*0.63in(L*W*H)
Installation hole diameter: 3mm/0.12in
The power supply voltage is DC6.5V-27V, the power supply cannot be reversed or exceed 27V, otherwise, the module may be burned out. It is recommended to connect a 15A fuse in series at the power input terminal.
Dual motor interface, with each rated output current of 7A and peak current of 50A. The motor interface must not be short-circuited, and it is recommended to connect a 10A fuse in series
The enable signal and the forward and reverse control signal control the voltage at 3-6.5V
Enable signal terminal (ENA) input PWM for speed regulation, with a PWM frequency range of 0-10KHZ and a minimum PWM pulse width of 10us

Suitable motor parameters:
For motors with a rated voltage of 24V, it is appropriate to identify motors with a rated power of 115W or below, or motors with a rated current of 7A or below, which can operate at full capacity for extended periods.
For motors with a rated voltage of 12V, it is appropriate to identify motors with a rated power of 40W or below, or motors with a rated current of 7A or below, which can operate at full capacity for extended periods.
ProductSiteLaunchDate : 2023-06-16T11:10:07.178Z
SupplierDeclaredDgHzRegulation : not_applicable
UnspscCode : 26111500
Voltage : 27 volts_of_direct_current
Wattage : 1.4 kilowatts