Cart 2 india

Specification
Brand : GODIYMODULES
BulletPoint : Carus Tool FUJI SC-N8 Contactor 110V AC New 1PCS
BulletPoint1 : 5Pcs 2 Channel DRV8833 Motor Drive Module 1.5A Dual H Bridge DC Gear Motor Driver Controller Board
BulletPoint2 : Board Size: 18.5 * 16mm Input voltage: 3--10V
BulletPoint3 : Single H-bridge output current: 1.5A, can drive two DC gear motors.
BulletPoint4 : Built-in over-current protection, short circuit protection, undervoltage lockout and overtemperature protection. With a low-power sleep mode. Applicaion: can drive 1.5A or less DC motor and 4-wire stepper motors
BulletPoint5 : ULT: low sleep mode (need to disconnect the rear of the module J2 shorted solder joints) OUT1,0UT2 :1 channel H-bridge, the corresponding control IN1, IN2. OUT3,0UT4 is a second road H-bridge, the corresponding control IN3, IN4. EEP to protect the output, not the default. VCC :the input voltage 3 to 10V GND: Ground.
BulletPoint6 : [Application]Suitable for all AC small motors, vibration motors, blowers ect
Color : Black
ExternallyAssignedProductIdentifier : 7341867435585
ExternallyAssignedProductIdentifier1 : 0754959885026
ExternallyAssignedProductIdentifier2 : 754959885026
IncludedComponents : 5PCS
ItemName : 5Pcs 2 Channel DRV8833 Motor Drive Module 1.5A Dual H Bridge DC Gear Motor Driver Controller Board
ItemPackageDimensions_Height : 2.03 centimeters
ItemPackageDimensions_Length : 10 centimeters
ItemPackageDimensions_Width : 5 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : electric-motor-controls
Manufacturer : GODIYMODULES
Material : Metal
ModelName : Jauarta1z85oexhpa
ModelNumber : Jauarta1z85oexhpa
NumberOfItems : 5
PartNumber : Mod-DRV8833-005
ProductDescription :

Description

Board Size: 18.5 * 16mm

Input voltage: 3--10V

Single H-bridge output current: 1.5A, can drive two DC gear motors.

Built-in over-current protection, short circuit protection, undervoltage lockout and overtemperature protection. With a low-power sleep mode.

Applicaion: can drive 1.5A or less DC motor and 4-wire stepper motors

Pinout:

ULT: low sleep mode (need to disconnect the rear of the module J2 shorted solder joints)

OUT1,0UT2 :1 channel H-bridge, the corresponding control IN1, IN2.

OUT3,0UT4 is a second road H-bridge, the corresponding control IN3, IN4.

EEP to protect the output, not the default.

VCC :the input voltage 3 to 10V

GND: Ground.

ProductSiteLaunchDate : 2025-02-17T07:30:36.634Z
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnspscCode : 26111500
Voltage : 24 volts