Cart 2 india

Specification
Brand : Everflow
BulletPoint1 : Easy two step process (drill Hole & drive Sammy's concrete anchor); 1/4 inch pre-drilled pilot Hole Required
BulletPoint2 : Allows specifiers and designers to engineer Systems with fewer attachment points
BulletPoint3 : Reduces occurrences of Fastener failure due to over driving; Made in Usa
BulletPoint4 : It is Made with teks self-drilling Fasteners; ensures correct Installation Torque
BulletPoint5 : Ultimate pullout 2400 lbs; #14 Sw black nut Driver key
Color : Zinc
CustomerPackageType : Standard Packaging
DriveSystem : Phillips
ExteriorFinish : Alloy Steel
ExternallyAssignedProductIdentifier1 : 804595136683
ExternallyAssignedProductIdentifier2 : 0804595136683
ExternallyAssignedProductIdentifier3 : 00804595136683
IncludedComponents : Actual Item
ItemName : Everflow Sammys 8058957-100 CST 200 1/4" Screw, Pack of 100, Zinc, 100 Piece
ItemPackageDimensions_Height : 21 inches
ItemPackageDimensions_Length : 13 inches
ItemPackageDimensions_Width : 13 inches
ItemPackageQuantity : 1
ItemTypeKeyword : concrete-screws
Manufacturer : Sammys
Material : Carbon Steel - Blue Coated
Material1 : Zinc
Material2 : Alloy Steel
MaximumShearStrength : 540
MeasurementSystem : Imperial
MetalType : Carbon Steel
ModelName : CST 200
ModelNumber : 8058957-100
NumberOfBoxes : 4
NumberOfItems : 4
NumberOfPieces : 100
PartNumber : 8058957-100
Pattern : Screw
PinType : Drive
ProductDescription : Applications
The anchor is made from Carbon Steel, and is Blue. This anchor is designed for use in Concrete, Block, and Brick.

Environment
The anchor is designed for use in a Dry environment.

Head Style
The anchor is a Flat Countersunk Phillips head and is designed to prevent the head from protruding above the surface of the item being attached.

Hole Diameter/Bit Diameter
The anchor requires a 5/32" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.

Driver Required
A #2 phillips bit is required for driving the anchor into the base material.

Diameter of Anchor
The diameter of the anchor is 3/16".

Length Anchor
The length of the anchor is 1-1/4"

Thread Length
The length of the threads on the anchor is 1-1/4" in length.

Minimum Embedment
The minimum anchor embedment into the concrete is 1". Therefore, the anchor must be installed so that a minimum of 1" of the anchor is embedded into the concrete.

Maximum Fixture Thickness
The maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 0" to 1/4". This will ensure that the minimum embedment of 1" will be met.

Fixture Hole Diameter
The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 3/16" diameter anchor requires the hole in the fixture to be 1/4".

Spacing between Anchors
Each anchor must be spaced a minimum distance of 3" from each other when measured center to center.

Edge Distance
It is very important not to install the anchor any closer than 2-1/4" from an unsupported edge of the concrete.
ProductSiteLaunchDate : 2017-07-01T04:58:39.629Z
Size : Pack of 100
SupplierDeclaredDgHzRegulation : unknown
UnitCount : 100
UnspscCode : 31161500