Cart 2 india

Specification
Brand : Electron Microscopy Sciences
BulletPoint1 : Use small tissue pieces, smaller volume of cell pellets
BulletPoint2 : Use separate programs for embedding and polymerization
BulletPoint3 : Use the smallest amount of resin in the embedding step
BulletPoint4 : During polymerization do NOT lower the pressure to a level equal to or lower than the saturated vapor pressure as any trace amount of sol-vent will result in the formation of holes in the specimen
ExternallyAssignedProductIdentifier : 4562108503761
ItemName : EMS Poly III
ItemPackageDimensions_Height : 3 centimeters
ItemPackageDimensions_Length : 10 centimeters
ItemPackageDimensions_Width : 8.5 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : science-lab-cellware-chambers
Manufacturer : EMS
ModelNumber : 4444
NumberOfItems : 1
PartNumber : 4444
ProductDescription : The EMS Poly III reduces lengthy and sometimes tedious manual embedding procedures for electron microscopy to a few simple steps for up to 52 vials. It uses a proper combination of pressure and temperature. The specimen chamber is temperature controlled from room temperature to 70 degree C. The pressure in the chamber can be reduced from ambient pressure with an inbuilt vacuum-pump that controls pressure to within narrow limits and warrants solvents will evaporate without the risk of explosive boiling. The exhaust of the vacuum pump can vent into a fume hood.

The instrument modifiable preset programs are optimized for an efficient removal of solvent from specimens eliminating the risk of boiling. Bulk removal of solvent is followed by the thorough removal of trace amounts.

Load at the end of a workday and (when using acetone or propylene oxide) the next morning are ready for polymerization after being topped off with pure resin.
ProductSiteLaunchDate : 2016-07-13T15:48:31.278Z
Size : EA
UnspscCode : 41000000