Cart 2 india

Specification
Brand : Aexit
BulletPoint1 : Output Type: NPN NC(Normal Close); Thread Size: 38mm; Detecting Distance: 1-20mm (Read description befor purchase); Detecting Object: Metal, Water, Glass,etc (See conditions in the description!!!)
BulletPoint2 : Supply Voltage: DC 6-36V; Current Output: 300mA(resistive load); Operating Temperature: -25C to +65C (Non-freezing Condition)
BulletPoint3 : Cable Length: 2m/6.56ft; Country of Manufacture: CHINA; Material: Electronic Parts
BulletPoint4 : Net Weight: 190g; Package Content: 1 x Capacitive Proximity Switch; Model: LJC38A4-20-Z/AX
BulletPoint5 : Wire Type: DC 3 Wire Type; Switch Appearance Type: Cylinder Type; Theory: Capacitance Sensor
ExternallyAssignedProductIdentifier : 9588083299975
ItemName : Aexit LJC38A4-20-Z/AX 1-20mm Control electrical Capacitance Proximity Sensor Switch NPN NC DC 6-36V 300mA
ItemPackageDimensions_Height : 3.5 centimeters
ItemPackageDimensions_Length : 12 centimeters
ItemPackageDimensions_Width : 8 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : capacitive-proximity-sensors
Manufacturer : Aexit
Material : Metal
ModelNumber : modle
OperatingVoltage : 36 volts
PartNumber : f190412ae103495
ProductDescription : Description:
0
NOT ALL MATERIAL ARE SUBJECT TO THE 20MM DETECTING RANGE.
0
3 factors that affect the function of the sensor:
0
1. Material density. Most of plastic material is not detectable by a capacitive proximity sensor at a proper distance, sometimes becasue the density is low , sometimes because the plastic is too thin, for example, if you detect an empty 1mm thick plastic bottle, the detecting distance may be less than 2mm , if you fill the bottle with water ,then the detection distance could be longer than 5mm.
2. The Sensitivity, when the sensor cannot work, there is a sensitivity-adjustment screw on the back of the sensor, you can turn it clockwise with a flat head screwdriver to increase the sensitivity of the sensor
3. Load Current . High output current can result in prodct failue, Inductive load (for instance, motors which draw high current when started) is not allowed to be directly connected with this sensor, because this sensor can only provide 300mA current for the load , you can use this sensor to provide a low level signal for a PLC which requires very little current ,or you can control a small relay that requires a coil current less than 100mA.
ProductSiteLaunchDate : 2019-01-04T08:06:20.900Z
SupplierDeclaredDgHzRegulation : not_applicable
SwitchType : Temperature Switch
UnitCount : 1
UnspscCode : 39122200