Cart 2 india

Specification
AgeRangeDescription : adult
Brand : GODIYMODULES
BulletPoint1 : Capacitive type touch switch module The module is based on a touch detection IC (TTP223B)'s. Under normal conditions, the module output low, low-power mode to mode; touch of a finger when the corresponding position, the module will output high, the mode is switched to fast mode; when for 12 seconds without touching, the mode and switch to low power mode.
BulletPoint2 : For Jog type: the initial state is low, high touch, do not touch is low (similar touch of a button feature)
BulletPoint3 : Power supply for 2 ~ 5.5V DC
BulletPoint4 : Control Interface: A total of three pins (GND, VCC, SIG), GND to ground, VCC is the power supply, SIG digital signal output pin;
BulletPoint5 : Power Indicator: Green LED, power on the right that is shiny;
Color : Npn Nc
ExternallyAssignedProductIdentifier : 6904857831029
IncludedComponents : 5PCS
ItemName : 5PCS TTP223 Capacitive Touch Switch Module TTP223B Digital Touch Sensor Module Capacitive Touch Sensor Switch
ItemPackageDimensions_Height : 2 centimeters
ItemPackageDimensions_Length : 10 centimeters
ItemPackageDimensions_Width : 5.02 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : capacitive-proximity-sensors
Manufacturer : GODIYMODULES
ModelName : DOPZNJWF
ModelNumber : DOPZNJWF
NumberOfBoxes : 1
NumberOfItems : 5
PartNumber : TTP223B-005
ProductDescription :

TTP223 Touch Switch Module TTP223B Digital Touch Sensor Module Capacitive Touch Switch 1 Channel for Arduino DIY Kit

Capacitive type touch switch module The module is based on a touch detection IC (TTP223B)'s. Under normal conditions, the module output low, low-power mode to mode; touch of a finger when the corresponding position, the module will output high, the mode is switched to fast mode; when for 12 seconds without touching, the mode and switch to low power mode. 

 

Module features are as follows:

1. For Jog type: the initial state is low, high touch, do not touch is low (similar touch of a button feature)

2. Low power consumption

3. Power supply for 2 ~ 5.5V DC

4. Touch surface can be used as positive and negative, can replace the traditional touch of a button

5. 4 M2 screws positioning holes for easy installation

6. Control Interface: A total of three pins (GND, VCC, SIG), GND to ground, VCC is the power supply, SIG digital signal output pin;

7. Power Indicator: Green LED, power on the right that is shiny;

8. Touch area: Similar to a fingerprint icon inside the area, you can touch the trigger finger.

9. Positioning holes: 4 M2 screws positioning hole diameter is 2.2mm, the positioning of the module is easy to install, to achieve inter-module combination;

ProductSiteLaunchDate : 2025-02-22T07:33:44.969Z
Size : LJC30A3-H
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnitCount : 1
UnspscCode : 39122200