Cart 2 india

Specification
Brand : YFUSET
BulletPoint : Model: Capacitive Proximity Sensor Approach Switch
BulletPoint1 : The front and back of the sensor can be used as a touch surface, replacing the traditional light touch button
BulletPoint2 : The sensor touch surface size: 14mm*14mm/0.55in*0.55in; Power supply voltage: 2.0-5.5V, penetration distance: 6mm
BulletPoint3 : The sensor has modes: joging, self-locking; Self-locking mode: press and hold the output once, and press again to stop the output (the output is high or low); Jog mode: Press the output, release to stop the output.
BulletPoint4 : The sensor has 4 M2 screw positioning holes with a hole diameter of 2.2mm, which is convenient for module installation and positioning, and realizes diversified combinations between modules
BulletPoint5 : Application: It can control LED modules, light strips and other products. It is suitable for indoor table lamps, LED lighting, DIY car lamp modifications.
ExternallyAssignedProductIdentifier1 : 0768383220537
ExternallyAssignedProductIdentifier2 : 768383220537
ItemName : 20pcs TTP223B Touch Sensor Module One-Channel Touch Switch DC2.0-5.5V 3-Pin Sensor
ItemPackageDimensions_Height : 0.2 inches
ItemPackageDimensions_Length : 0.2 inches
ItemPackageDimensions_Width : 0.2 inches
ItemTypeKeyword : capacitive-proximity-sensors
Manufacturer : YFUSET
PartNumber : ZGW-48
ProductDescription :

Product Name: TTP223B Touch Sensor Module 

Power supply voltage VCC: 2.0~5.5V

Output High VOH: 0.8VCC-V

Output Low VOL: 0.3V

Output Pin Sink Current: 8mA (@VCC=3V, VOL=0.6V)

Output Pin Source Current: -4mA (@VCC=3V, VOH=2.4V)

Response time: 220mS (low power mode); 60mS (Fast Mode)

Size: 24*24*7.2mm/0.94in*0.94in*0.28in

Weight: Approx. 2.7g/0.09oz

Control interface: a total of 3 pins (GND, VCC, SIG), GND is ground, VCC is power supply, SIG is digital signal output pin;

Power indicator: green LED, glow when powered on correctly;

Touch area: The inner area of the fingerprint-like icon, which can be triggered by a light touch of the finger.

Positioning holes: 4 M2 screw positioning holes, the hole diameter is 2.2mm, so that the module is easy to install and position, and the combination between modules is realized;

Product Introduction:

The module is a capacitive jog touch switch module based on a touch detection IC (TTP223B).

Under normal conditions, the output of the module is low, and the mode is low-power mode; When touching the corresponding position with your finger,

The module will output a high level, and the mode will be switched to fast mode; When there is no touch for 12 seconds, the mode switches to low-power mode again.

You can install the module on the surface of non-metallic materials such as plastic and glass, and cover the surface of the module with a thin piece of paper (non-metal), as long as the touch position is correct, you can make a hidden button on the wall, desktop, etc.

This module can help you solve the problem of regular push-type buttons. 

ProductSiteLaunchDate : 2024-09-18T12:45:13.523Z