Cart 2 india

Specification
Brand : SÜA
BulletPoint1 : LFBF (Fluxcoated low fuming bronze) is a general purpose oxyacetylene/brazing rod used for joining various ferrous and non-ferrous metals such as carbon steel, copper alloys, cast iron, malleable iron, stainless steel and some nickel alloys. Mechanical and physical characteristics include ductility, machineability, high strength, free flowing with good tinning action and a low melting point (1630°F)
BulletPoint2 : A “must have” filler metal for every machine shop, LFBF is excellent for building up wearing surfaces or large areas where successive layers must be added; galvanized parts can be brazed without damaging the zinc coating. Precise balance of copper and zinc along with alloying elements of tin, iron, manganese and silicon produces weld deposits that can be easily machined but work harden once put into service; high silicon level promotes low fuming
BulletPoint3 : ***READ THIS: Main image is for reference only. Please check Picture #2 for an approximate quantity of rods per pound***
BulletPoint4 : Available in different sizes: 1/16", 3/32"and 1/8". Rod Length: 18" for easier maneuverability while welding since flux coated rods cannot be bend. These SÜA rods have the alloy and rod diameter printed on the coat for easier identification.
BulletPoint5 : Available in different package weights: 1/2 Lb, 1 Lb, 2 Lb and 5 Lb - Choose rod diameter and package quantity from the menu.
ExternallyAssignedProductIdentifier : 00840338553805
ItemDisplayWeight : 2.5 pounds
ItemName : SÜA® - RBCuZn-C - Low-Fuming Bronze Brazing Rod - Flux Coated - 18" x 1/16" - (2.5 Lb)
ItemPackageDimensions_Height : 1.37 inches
ItemPackageDimensions_Length : 11 inches
ItemPackageDimensions_Width : 2.5 inches
ItemPackageQuantity : 40
ItemTypeKeyword : brazing-rods
Manufacturer : Mundaka Technologies Inc
Material : bronze
NumberOfBoxes : 1
NumberOfItems : 40
PartNumber : SWT-LFBF2.5X18X116_2.5
ProductDescription : Recommended Braze-Welding Procedure: Preheating is recommended for some applications, however, overheating should be avoided. Voids may be formed in the joint by entrapped zinc vapors. Bevel cracks or heavy sections. Clean the area to be brazewelded as thoroughly as possible. Joint clearances of 0.002” – 0.005” (0.05 – 0.13mm) are suitable. Using a slightly oxidizing flame, preheat the part to be brazed. If using LFB, dip the rod into the bronze brazing flux (there is no need for more flux if using LFBFC) and then back to the area being brazed, while keeping the torch in constant motion to avoid overheating. The molten drops of LFB or LFBFC will follow the heat of the torch flame. Repeat the process until the joint is filled (Note: A benefit to using LFBFC over LFB is that it is not necessary to remove flux residue between passes). Allow the part to cool slowly before removing any slag, then use a wire brush to bring out a nice yellow brass color.
ProductSiteLaunchDate : 2022-11-10T19:16:26.743Z
Size : 1/16" - 2.5 Lb
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnitCount : 1