Cart 2 india

Specification
Brand : TGB
BulletPoint1 : Lower melting point and higher fluidity
BulletPoint2 : No additional flux is needed and can be used directly with Oxy-Acetylene / Oxy-MAPP flame brazing
BulletPoint3 : Recommended for welding most aluminum and magnesium alloys
BulletPoint4 : Doesn´t need to be washed after welding, no acid cleaning needed
BulletPoint5 : Lenght: 39 Inch - Dia: 0.080 Inch - 4 Lb Package
Color : Golden
ExternallyAssignedProductIdentifier1 : 703856605985
ExternallyAssignedProductIdentifier2 : 0703856605985
FinishType : Chrome
IncludedComponents : Solder Sucker
ItemDisplayDimensions_Height : 0.79 centimeters
ItemDisplayDimensions_Length : 7.32 centimeters
ItemDisplayDimensions_Width : 0.87 centimeters
ItemDisplayWeight : 4 pounds
ItemName : Flux Cored Aluminum Solder ER4047 Brazing Rod - 39" x 0.080" (2.0 mm) (4 Lb)
ItemPackageDimensions_Height : 2.362204722 inches
ItemPackageDimensions_Length : 0.9842519675 inches
ItemPackageDimensions_Width : 9.448818888 inches
ItemPackageQuantity : 1
ItemTypeKeyword : brazing-rods
Manufacturer : TGB
Material : magnesium
ModelNumber : VTD4
NumberOfItems : 1
NumberOfLithiumMetalCells : 1
PartNumber : 4047FCRX80_4
ProductDescription : ER4047 Flux Cored is one of the most popular aluminum brazing rods. It is 12% silicon alloyed for a lower melting point and higher fluidity than ER4043. No additional flux is needed and can be used directly with Oxy-Acetylene / Oxy-MAPP flame brazing or induction welding. ER4047 Flux Cored can also be used as a welding filler metal in place of ER4043 to provide increased silicon in the weld metal, which will minimize hot cracking and produce higher fillet weld shear strengths. ER4047 Flux Cored is recommended for welding alloys 1060, 1350, 3003, 3004, 3005, 5005, 5050, 6053, 6061, 6951, 7005 and cast alloys 710.0 and 711.0. Its self-fluxing improves the welding quality, simplifies operation and increases producing rate. ER4047 aluminum flux cored brazing rods are made with environment-friendly and non-corrosive flux. Doesn´t need to be washed wash after welding, no acid cleaning needed and causes little harm to the base metal. Welding Parameters: ? Sand the welding position and work piece (oil, rust and oxide must be cleaned away). ? Heat welding position evenly by moving welding torch. ? When temperature reaches 1058 °F, (570°C), flux cored rod should be added. Then rod melts, and make it flow into the joint evenly. ? When the welding seam is full, move torch away. ? Cool down. Chemical Composition of ER4047 Flux Cored (%): Si Fe Cu Mn Mg Zn Al Others 12.0 0.80 0.30 0.15 0.10 0.20 Balance 0.15 Single values are maximum unless otherwise specified. Welding Temp(°C): 570-582 Welding Temp(°F): 1058-1080
ProductSiteLaunchDate : 2017-01-31T08:00:00.000Z
Size : 4 Lb
Style : centimeter
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 1