Cart 2 india

Specification
Brand : Blue Demon
BulletPoint1 : Balls up easily in AC applications
BulletPoint2 : Good arc starting and current capacity
BulletPoint3 : This product is non-radioactive
BulletPoint4 : Available in different sizes: 1/16", 3/32"and 1/8". Rod Length: 18" for easier maneuverability while welding since flux coated rods cannot be bend. These SÜA rods have the alloy and rod diameter printed on the coat for easier identification.
BulletPoint5 : Available in different package weights: 1/2 Lb, 1 Lb, 2 Lb and 5 Lb - Choose rod diameter and package quantity from the menu.
ExternallyAssignedProductIdentifier : 00840338553782
ExternallyAssignedProductIdentifier1 : 652426001064
ExternallyAssignedProductIdentifier2 : 0652426001064
ExternallyAssignedProductIdentifier3 : 00652426001064
IncludedComponents : Tungsten
ItemDisplayWeight : 0.64 pounds
ItemName : Blue Demon Welding Tungsten Electrodes, 0.3% Zirconiated, BROWN, EWZr-1, 1/8 in x 7 in 10 pc pack TE3Z-18-10T
ItemPackageDimensions_Height : 20.3 centimeters
ItemPackageDimensions_Length : 0.6 centimeters
ItemPackageDimensions_Width : 5.8 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : brazing-rods
Manufacturer : Welding Material Sales
Material : tungsten
ModelName : TE3Z-18-10T
ModelNumber : TE3Z-18-10T
NumberOfBoxes : 1
NumberOfItems : 1
PackageLevel : unit
PartNumber : TE3Z-18-10T
PowerSourceType : AC
ProductDescription : Recommended Braze-Welding Procedure: Preheating is recommended for some applications, however, overheating should be avoided. Voids may be formed in the joint by entrapped zinc vapors. Bevel cracks or heavy sections. Clean the area to be brazewelded as thoroughly as possible. Joint clearances of 0.002” – 0.005” (0.05 – 0.13mm) are suitable. Using a slightly oxidizing flame, preheat the part to be brazed. If using LFB, dip the rod into the bronze brazing flux (there is no need for more flux if using LFBFC) and then back to the area being brazed, while keeping the torch in constant motion to avoid overheating. The molten drops of LFB or LFBFC will follow the heat of the torch flame. Repeat the process until the joint is filled (Note: A benefit to using LFBFC over LFB is that it is not necessary to remove flux residue between passes). Allow the part to cool slowly before removing any slag, then use a wire brush to bring out a nice yellow brass color.
ProductSiteLaunchDate : 2015-06-24T08:00:01.000Z
Size : 1/8"
SupplierDeclaredDgHzRegulation : not_applicable
UnitCount : 10
UnspscCode : 39121400