Cart 2 india

Specification
Brand : Medduw
BulletPoint1 : ★Basic information: This pair of end caps is an installation accessory for universal outdoor/indoor roller shutters.
BulletPoint2 : ★Package included: A pair of end caps of roller blinds.
BulletPoint3 : ★Size: Outer diameter : about 1.22 inch, Inner diameter : about 0.71 inch.
BulletPoint4 : ★Easy to install: It's easy to replace and install, You only need to insert the end caps into the left and right sides of the lower rod of the roller blind.
CareInstructions : Spot Clean
Color : Beige
ControlType : Manual
ExternallyAssignedProductIdentifier1 : 742579458386
ExternallyAssignedProductIdentifier2 : 0742579458386
IncludedComponents : 安装硬件
ItemName : Universal Replacement of The Outdoor/Indoor Roller Blind and Roller Shade (Beige, End Cap)
ItemPackageDimensions_Height : 5.4102 centimeters
ItemPackageDimensions_Length : 2.794 centimeters
ItemPackageDimensions_Width : 4.4958 centimeters
ItemPackageQuantity : 1
ItemShape : Rectangular
ItemTypeKeyword : hardware-brackets
Manufacturer : Litong
Material1 : Plastic
Material2 : Wood
MountingType : Indoor,Outdoor
NumberOfItems : 2
Opacity : Blackout adult_us
OperationMode : Manual
PatternType : Solid
ProductDescription : Bracket mounting operation:
Mounting brackets can be mounted horizontally or vertically.
After determining location to install mounting brackets,
use bracket as template to mark hole positions for pre-drilling holes in surface for insertion of plastic anchors.
Installation note: 1. The mounting bracket can be installed horizontally or vertically,
depending on the fixture to which the sun visper is to be installed.
After determining the position of the mounting bracket,
use the bracket as a template to mark the position of the holes in the surface pre-drilled holes to insert the plastic anchor.
2. The bracket will be installed to solid wood, plastic anchor is not necessary to install.
Plastic anchors are required for other media, such as concrete or stone. After drilling,
insert the plastic anchor into the hole until it is level with the surface.
Remove the four screws. Turn the clutch unit 90 degrees so that the clutch eye hangs from the top,
the clutch eye hangs straight, and then turn the idle end unit so that the opening is facing away from the window.
3. The final step is to install bungee ropes and ring brackets strapped to the end of the shade.
This is used to help tie the shade in windy weather. Mount the bracket in the side position.
Make sure that each bracket is at least 6 feet from the top of the shade and can be reached by bungee rope.
ProductSiteLaunchDate : 2021-03-01T09:28:11.753Z
RecommendedUsesForProduct : 戶外
RoomType : 家庭办公室
Size : End Cap
SpecificUsesForProduct : 家居装饰
SupplierDeclaredDgHzRegulation : not_applicable
UnspscCode : 52130000
WaterResistanceLevel : not_water_resistant