Cart 2 india

Specification
Brand : Haglof
BulletPoint1 : Use to extract cores of wood from trees or freshly treated poles, piling, lumber, or timbers
BulletPoint2 : Teflon coating protects bit against rust and resin build-up and reduces friction
BulletPoint3 : 0.169” is commonly used for general forestry use
BulletPoint4 : 0.200” for wood preserving testing
BulletPoint5 : 0.500” for large amounts of wood for qualitative analysis
CuttingAngleString : 120.0 degrees
ExternallyAssignedProductIdentifier1 : 0000140478622
ExternallyAssignedProductIdentifier2 : 000140478622
ExternallyAssignedProductIdentifier3 : 00728709109939
IncludedComponents : 1pcs boring bar & 10 pcs carbide inserts
ItemName : Haglöf 2-Thread Increment Borers (16"L x 0.200" (5.15mm) Dia.)
ItemPackageDimensions_Height : 2 inches
ItemPackageDimensions_Length : 5 inches
ItemPackageDimensions_Width : 2 inches
ItemPackageQuantity : 1
ItemTypeKeyword : boring-bars
Manufacturer : Haglof
Material : Alloy Steel
ModelNumber : TDJNR12-4B
NumberOfItems : 1
PartNumber : 404-7862
Pattern : 16"L x 0.200" (5.15mm) Dia.
ProductDescription : Use to extract cores of wood from trees or freshly treated poles, piling, lumber, or timbers to determine growth rate, age, tree soundness, and chemical penetration. Teflon coating protects bit against rust and resin build-up and reduces friction. How to select the correct Increment Borer for your needs. Three factors to consider when ordering an increment borer are bit length, core diameter and thread style. Borer Bit Length depends on the size of the trees you will be boring. Length is measured from the tip of the threads to the end of the round section of the borer bit. This is the maximum depth the bit will penetrate. Core Diameter of the wood sample is determined by the inside diameter of the opening at the threaded end of the bit. 0.169” is commonly used for general forestry use, 0.200” for wood preserving testing and 0.500” for large amounts of wood for qualitative analysis. 2- or 3-Thread style is a matter of personal preference. A 2-thread borer has two threads on the cutting edge of the bit, each originating 180° apart. A 3-thread borer has three threads, each originating 120° apart. The higher thread pitch of the 3-thread borer will penetrate deeper per revolution than a 2-thread. A 3-thread will also produce less friction because more steel is in contact with the wood. The ease at which a borer penetrates wood depends on wood hardness, friction properties and capability/strength of the user.
ProductSiteLaunchDate : 2015-03-13T15:37:57.846Z
Size : S25S-SVXCR16
StreetDate : 2017-11-25T00:00:01Z
Style : T-Type Clamp
SupplierDeclaredDgHzRegulation : not_applicable
SurfaceRecommendation : Wood
UnitCount : 1
UnspscCode : 27111700