Cart 2 india

Specification
Brand : Electronics123.com, Inc.
BulletPoint : 1*AAA Battery Holder SMD Surface Mount
BulletPoint1 : Sure, your flashing, chip-tune playing t-shirt is really cool at the party… but at some point you need to turn it off.
BulletPoint2 : And yes, you could just pull the battery, or maybe you’ve even sewn a LilyPad slide switch in-line.
BulletPoint3 : Wouldn’t it be nice if there was just a switch on the battery? Well look no further.
BulletPoint4 : This LilyPad Coin Cell Battery Holder has a small slide switch installed on the board, in-line with the power so you can shut off your project and save batteries.
BulletPoint5 : Skill Level : Assembled and Tested
CompatibleDevices : LilyPad Projects
ConnectivityTechnology : Proprietary
ConnectorType : Proprietary
ExternallyAssignedProductIdentifier : 3814442758132
ExternallyAssignedProductIdentifier1 : 611138684798
ExternallyAssignedProductIdentifier2 : 0611138684798
FormFactor : Board with battery slot
IncludedComponents : 2 x Screw
IsPortable : 1
ItemName : Electronics123.com, Inc. Lilypad Coin Cell Battery Holder - Switched - 20mm
ItemPackageDimensions_Height : 0.25 inches
ItemPackageDimensions_Length : 3 inches
ItemPackageDimensions_Width : 2.5 inches
ItemPackageQuantity : 1
ItemTypeKeyword : battery-holders
Manufacturer : LillyPad
ModelNumber : BAT-HL0030
NumberOfItems : 1
NumberOfPowerLevels : 1
OutputVoltage : 3 volts_of_direct_current
PartNumber : DEV-13883
PowerPlugType : no_plug
ProductDescription :

Sure, your flashing, chip-tune playing t-shirt is really cool at the party… but at some point you need to turn it off.

And yes, you could just pull the battery, or maybe you’ve even sewn a LilyPad slide switch in-line.

Wouldn’t it be nice if there was just a switch on the battery? Well look no further.

This LilyPad Coin Cell Battery Holder has a small slide switch installed on the board, in-line with the power so you can shut off your project and save batteries.

This slide switch is the same as is found on the LilyPad slide switch board, so it’s not easy to accidentally turn off or on.

Just like the original Coin Cell Battery Holder, this simple board holds a 20mm coin cell battery (such as a CR2032) and gives you 4 connection points (two positive and two negative) for sewing into your project.

ProductSiteLaunchDate : 2017-02-22T22:13:26.799Z
Reusability : Single Use
SupplierDeclaredDgHzRegulation1 : not_applicable
SupplierDeclaredDgHzRegulation2 : not_applicable
SupplierDeclaredDgHzRegulation3 : not_applicable
SupplierDeclaredDgHzRegulation4 : not_applicable
SupplierDeclaredDgHzRegulation5 : not_applicable
UnitCount : 1
UnspscCode : 26111700
Wattage : 1 watts