Cart 2 india

Specification
Brand : Jolooyo
BulletPoint : 5pcs TOP255EN ESIP-7 TOP255 SIP-7 TOP255E TOP255EG TOP258EN TOP258EG TOP261EN TOP261EG TOP262EN TOP262EG TOP265EG TOP266EG
BulletPoint1 : Operating frequency: 1200-1320MHz (1268).
BulletPoint2 : Output power: 13W (41dBmmeter 24V Magneto RFindle 5dBm (3mW)).
15W (42dBmcast 28V Magneto RFindle 5dBm (3mW)).
20W (43dBmless 28V Magne7dBm (5mW)).

BulletPoint3 : Operating voltage: 20-28V (recommended 24V).
BulletPoint4 : Working current: 1.7A (depending on the supply voltage).
BulletPoint5 : System impedance: 50 ohms.
ExternallyAssignedProductIdentifier1 : 0708310529104
ExternallyAssignedProductIdentifier2 : 708310529104
IncludedComponents : 1pc RF Power Amplifier
ItemName : RF Power Amplifier 1250MHz Output 15W Gain 40dB
ItemPackageQuantity : 1
ItemTypeKeyword : electronic-component-audio-amplifiers
Manufacturer : Jolooyo
Material : Copper
MaximumSwitchingVoltage : 5 volts
ModelNumber : tuoluo590 1250MHz
MountingType : Surface Mount
NumberOfItems : 1
OperationMode : Automatic
PartNumber : tuoluo590 1250MHz
ProductDescription : 1250MHz RF power amplifier.
(1200-1320MHz 15W).


1. Operating frequency: 1200-1320MHz (1268).

2. Output power: 13W (41dBmmeter 24V Magneto RFindle 5dBm (3mW)).

15W (42dBmcast 28V Magneto RFindle 5dBm (3mW)).

20W (43dBmless 28V Magne7dBm (5mW)).

3. Operating voltage: 20-28V (recommended 24V).

4. Working current: 1.7A (depending on the supply voltage).

5. System impedance: 50 ohms.

6. External dimensions: 76*40*16.5mm (excluding connectors).

7. Product weight: 95g.

8. Joint model: SMA female head (inner hole of outer screw).

9. Note: additional heat sink is required

Important reminder

Before using the RF amplification module sold in our store, it is necessary to ensure that all instruments and equipment are grounded together (without potential difference),
Then connect with an RF cable, and be sure to connect to the load. It is strictly prohibited to use it without load, especially for power amplifiers.
Be sure to use a "serious" antenna, especially when using the antenna as a load. Ensure that the impedance of the antenna matches within the working frequency (generally requiring a voltage standing wave ratio of less than 2.0). It is strictly prohibited to use "unprofessional" antennas, such as rod antennas, copper wire antennas, and expensive antennas that have no definite impedance.
Try to use a linear power supply as much as possible, especially when using a low-noise amplifier. It is necessary to use a linear power supply or battery. The noise of the switching power supply itself is very high, and these noises will be connected to the amplification circuit. Do not use a switching power supply.


ProductSiteLaunchDate : 2024-05-14T08:50:22.925Z
Size : TOP258EN
Style : Diaphragm
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1