Cart 2 india

Specification
Brand : Geekstory
BulletPoint1 : This DY-180 TTL GPS Module can show your speed. When you use it for Raspberry Pi, there is no driver needed. Here is connection with RPi, red to 3.3v, black to gnd, green to txd, white to rxd
BulletPoint2 : The PW LED flash means gps module output normally. The PPS LED flash means gps module locate your place. Note: without PPS output, only PPS indicator
BulletPoint3 : Data Level : TTL or RS-232, Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable
BulletPoint4 : This DY-180TTL GPS Module does not have FLASH and cannot be saved. 72 Searching Channel Support Rate : 4800bps to 921600bps, Default 9600bps
BulletPoint5 : What you will get: 1 X DY-180TTL GPS Module, 3 X 4P 1.0mm Pitch Cable
ConnectivityTechnology : 1.0mm Pitch Cable
ControlMethod : touch
HumanInterfaceInput : unknown
IncludedComponents : 1 X DY-180TTL GPS Module, 3 X 4P 1.0mm Pitch Cable
ItemName : Geekstory DY-180TTL GPS Receiver Module Dual Glonass GPS Navigation Module TTL Level 9600bps with GPS Antenna for Arduino FPV Aircraft,Replace BN-180 GPS
ItemPackageDimensions_Height : 0.35 inches
ItemPackageDimensions_Length : 2.73 inches
ItemPackageDimensions_Width : 1.81 inches
ItemPackageQuantity : 1
ItemTypeKeyword : gps-antennas
Manufacturer : Geekstory
MountingType : Panel Mount
ProductDescription : Description:
Support GPS+GLONASS (default); GPS+ Beidou; GLONASS+ Beidou multi-mode output
Built-in LNA signal amplifier
Built-in TCXO crystal and Fara capacitor for faster hot start
1-10Hz positioning update rate
Baud rate 4800bps-921600bps (default 9600bps)
Channel: 72CH
Horizontal accuracy: 2.0m
Output level TTL level
Output Protocol NMEA0183 Standard Protocol
Update frequency 1-10 Hz (default 1Hz)
Connector: 4Pin 1.0mm Pitch

Package Includes:
1 X DY-180TTL GPS Module
3 X 4P 1.0mm Pitch Cable

ProductSiteLaunchDate : 2023-08-28T02:54:36.030Z
Size : DY-180
SupportedSatelliteNavigationSystem : gps
UnspscCode : 43220000