Cart 2 india

Specification
Brand : CANPUMP
BulletPoint1 : Rated pressure: 4050 psi (280 bar), Max. permissible pressure: 4500 psi (310 bar), Max. flow rate: 10 US gpm (40 L/min), Max. temperature: 195 °F (90 °C), Inlet/outlet/bypass: ⅜″ NPT F
BulletPoint2 : Unloader valve with 2 ports each for inlet and bypass, and a knob on the pressure regulator for convenient adjustment.
BulletPoint3 : Quality Replacement Unloader Valvefor All High Pressure pumpAR Comet Cat pump BE. Replacement for General Pump PULSAR4HP
BulletPoint4 : Bypass kit that includes a 2 ft bypass hose, water filter, a quick-connect plug and hose clamps.
BulletPoint5 : 7x5 toll-free phone, email and live chat support from Canada
Color : sliver
Color1 : Black
Color2 : Silver
Color3 : Blue
Color4 : White
ExternallyAssignedProductIdentifier : 6280709410124
ItemDisplayDimensions_Length : 100 feet
ItemName : P.A. Power Washer Unloader Valve Fully Plumbed Kit Pulsar 4/Rv – 4050 PSI 10.5 GPM
ItemPackageDimensions_Height : 9 inches
ItemPackageDimensions_Length : 6 inches
ItemPackageDimensions_Width : 9 inches
ItemTypeKeyword : pressure-washer-accessories
ItemTypeName : Nozzle
Manufacturer : Green Canpump Inc.
Material : Plastic
MaximumPressure : 4000 pounds_per_square_inch
ModelName : Nozzle
ModelNumber : Nozzle
NumberOfPorts : 2
PartNumber : Nozzle
ProductDescription :

•  Optimized internal passages that guarantee reduced pressure loss.
•  Antirotation device of the piston positioned inside the valve and obtained by an hexagonal sector of the piston itself.
•  O-rings of the fittings positioned upstream to the thread : no risk of fittings ejected in case of overpressure.
•  Double feed connection.
•  Version with knob fitted with locknut for minimum working pressure adjustment.

1) The valve has been designed for a continuous use with water at a temperature of 60°C (140°F). It can work for short periods with water at the maximum temperature of 90°C (195°F).

2) When the valve is in bypass mode, this is the decrease of pressure that has to occur in the circuit downstream of the valve, in order that the valve can restore the working pressure in the system. The indicated figure is expressed as a percentage of the pressure setting (working pressure).

3) If the valve is fed through the lower inlet port, the maximum flow rate is 20 l/min. At gun closure, a pressure increase occurs in the circuit downstream of the valve. This pressure increase is used to activate the valve and discharge all the flow in bypass. The value of the pressure increase cannot be calculated. It depends on the correct setting of the valve (see PRESSURE ADJUSTMENT/SETTING) and on the layout of the system: flow rate, working pressure, length and characteristic of the tubes, closing time of the gun.

ProductSiteLaunchDate : 2022-03-21T11:35:06.857Z
Size : 100 Feet
Style : Submersible
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnitCount : 1