Cart 2 india

Specification
Brand : Garosa
BulletPoint1 : [PERFECT CONNECT]---The front and rear covers are perfectly connected, the body is black electrophoresis, highend atmosphere, and the body size is standard.
BulletPoint2 : []----The inner rotor adopts German technology, and the is coated with imported rotor glue to prevent burrs on the after carbon steel oxidation and grinding, resulting in increased motor noise.
BulletPoint3 : [CHARACTERISTIC]----Imported highquality motor steel sheets, bearings made of German technology, low selfinductance, good responsiveness.
BulletPoint4 : [CONVENIENT TO USE]----The product can be directly connected to the load and run at low speed in a state of close to a locked rotor without gear reduction.
BulletPoint5 : [FUNCTION]----The product can produce a high torsiontoinertia ratio on the loaded shaft, and can eliminate system errors caused by the use of reduction gears.
Color : One Color
ExternallyAssignedProductIdentifier : 9495567733811
ExternallyAssignedProductIdentifier1 : 9495567733224
ExternallyAssignedProductIdentifier2 : 9495567733842
IncludedComponents : No
ItemName : 2 Phase Stepper Motor, 2Phase Electric Motor 42 Stepper 1.8 Degree 0.28Nm Stepping Driver NEMA17 Replacement for Transmission, Electric Motor
ItemPackageDimensions_Height : 6 centimeters
ItemPackageDimensions_Length : 8 centimeters
ItemPackageDimensions_Width : 6 centimeters
ItemPackageQuantity : 1
ItemTypeKeyword : 3d-printer-motors
Manufacturer : Garosa
Material : Aluminum
ModelName : Garosa2a7hkugt06
ModelNumber : Garosa2a7hkugt06
NumberOfItems : 1
PartNumber : Garosa2a7hkugt06
ProductDescription : Specification:
Item Type: Electric Motor
Material: Carbon steel
Purpose: Industrial motor control, transmission and transmission occasion
Step Angle: 1.8°
Voltage: Determined by the equipped driver, no fixed voltage
Current: 1.5A
Holding Torsion: 0.28N.m
Resistance: 2.4Ω
Inductance: 2.8mH/phase
Length: Approx. 34mm / 1.3in
Number of Outlets: 4
Shaft Type: Milling single flat table
Step Angle Accuracy: ±5% (full step)
Resistance Accuracy: ±10% (20)
Inductance Accuracy: ±20% (1KHZ)
Temperature rise 80 maximum (rated current, 2-phase energization)
Ambient Temperature: -20~+50
Insulation Resistance: 100MΩMin, 500VDC
Withstand voltage 500VAC for one minute
Radial Clearance: 0.02mm maximum (450g load)
Axial Clearance: 0.08mm maximum (450g load)
Maximum Radial Load: 28N (20mm from flange )
Maximum Axial Load: 10N

Package List:
1 x Electric Motor

Note:
1. When connecting the motor to the driver, do not connect the wrong phase.
2. Due to different driving conditions, the motor may have obvious heat generation. The temperature of the motor is not allowed to exceed 85°C during operation.
3. When installing the motor, be sure to use the front end cover of the motor for positioning, and pay attention to tolerances to ensure the concentricity of the motor shaft and the load.


ProductSiteLaunchDate : 2024-03-04T13:25:18.195Z
Size : 14.4V 13Teeth Motor
Speed : 15 rpm
UnitCount : 0.0353
Voltage : 500 volts