Cart 2 india

Specification
Brand : Generic
BulletPoint1 : 1. MA MB MC phase line output to the motor
BulletPoint2 : 2. 5V GND main board with its own 5V power supply (can be external power supply current does not exceed 50MA)
BulletPoint3 : 3. VCC GND main power supply (external DC power supply)
BulletPoint4 : 4. SC speed pulse signal output (only leave out the interface, not technical support)
BulletPoint5 : 5DIR direction control forward and reverse control interface (low-level effective external switch to ground)ItemName : DC6-60V 400W BLDC Three-phase DC Brushless Motor Controller PWM Hall Motor Control Driver Board Motor Driver Module 12V 24V 48V
ItemTypeKeyword : multitools
Manufacturer : DAVITU
PartNumber : DVT-13EDD9BDD562CCD057837C21A28E8309
ProductDescription : DC6-60V 400W BLDC Three-phase DC Brushless Motor Controller PWM Hall Motor Control Driver Board Motor Driver Module 12V 24V 48V
Note:
This driver is a DC three-phase brushless control board requires a motor with Hall to work properly
This driver is only applicable to the electric angle 120 degrees DC brushless with Hall motor
Newly upgraded BLDC wide voltage 6-60V high power 400W DC three-phase brushless with Hall controller, support PLC 0-5V analog control support PWM control amplitude 2.5-5V
External Signal Input Special Instructions:
1. From the motherboard P G 2 ports external PWM signal input (the board comes with a potentiometer to the minimum, while shorting the board short interface wiring see the diagram above) amplitude 2.5-5V, frequency 50HZ-20KHZ.
2. External analog 0-5V input, from the motherboard 2 terminals sub port input (the board comes with a potentiometer to the minimum, wiring see the above figure dashed line schematic)
3. External potentiometer speed control, from the motherboard 3 terminals sub port correspondingly connected (potentiometer on the board to the minimum, wiring see the above drawing potentiometer schematic)
4. forward and reverse and stop through a switch to ground (0 potential) low-level valid, can also be external MCU to give low-level signal. Brake through a switch to 5V high level valid The front row of terminals, are weak signals directly into the MCU main control, can not touch and contact with high voltage strong current.
Interface Descriptions:
1. MA MB MC phase line output to the motor
2. 5V GND main board with its own 5V power supply (can be external power supply current does not exceed 50MA)
3. VCC GND main power supply (external DC power supply)
4. SC speed pulse signal output (only leave out the interface, not technical support)
5DIR direction control forward and reverse control interface (low-level effective external switch to ground)ProductSiteLaunchDate : 2023-04-27T08:45:03.066Z
UnitCount : 1