Cart 2 india

Specification
Brand : Aladrs
BulletPoint1 : Compatible Models: 290x450mm ACF Film Compatible with phrozen Sonic Mega 8K, Anycubic Photon M7 Max.
BulletPoint2 : HIGH QUALITY MATERIAL: ACF Release Film is made of high quality qualified material. The smooth release side is coated with a blue protective film, which needs to be removed before use. The smooth release side is the side that comes into contact with the resin during use. When installing and removing the blue protective film, please lay the ACF release film flat on a clean table to avoid creases on the surface of the release film. The frosted back side faces the LCD screen.
BulletPoint3 : Smaller fluctuation: Compared with NFEP and FEP release film, ACF release film has less release force and less film deformation during printing, which can improve the success rate of printing and the detail performance of the model .
BulletPoint4 : Higher speed and durability: ACF has a lower release force, which allows it to support higher print speeds. At the same time, the smaller deformation of the resin during curing allows for finer printing and a longer service life.
BulletPoint5 : High Temperature Resistance: ACF film has higher heat resistance than nFEP and FEP, capable of long term stable operation at 500°F/260°C with a melting point of 580°F/305°C.
IncludedComponents : 3pcs ACF
ItemName : ALadrs 3PCS ACF Film for Sonic Mega 8K, ACF High Speed Release Film High Durability Dual Surfaces Less Peeling Force for Phrozen Sonic Mega 8K / Anycubic Photon M7 Max Resin 3D Printer
ItemPackageDimensions_Height : 32.7 centimeters
ItemPackageDimensions_Length : 5.9 centimeters
ItemPackageDimensions_Width : 5.9 centimeters
ItemTypeKeyword : 3d-printer-accessories
Manufacturer : Aladrs
NumberOfBoxes : 1
NumberOfItems : 3
PartNumber : ALA-3D-062
ProductDescription :

3pcs ACF Film 3D Printer Accessories, FEP Film for phrozen Sonic Mega 8K, Anycubic Photon M7 Max. 290*450mm.

Heat resistance: -240°C to 260°C

Suitable for high speed printing

Installation Procedure

1>Remove the screws and detach the steel ring from the resin drum.

2>Remove the screws, separate the steel ring and replace the ACF film.

3>Place the new ACF film between the two steel rings, then tighten the screws to install it back.

4>Install the steel rings back into the resin pail and make sure the ACF film is clean and properly tensioned.

Matters needing attention:

 1. Remove the protective film from the smooth side of the ACF film before use.

 2. The smooth side is the side in contact with the resin, and the frosted side faces the LCD.

ProductSiteLaunchDate : 2024-06-26T09:22:49.601Z
Size : For Sonic Mega 8K
SupplierDeclaredDgHzRegulation : not_applicable
SupplierDeclaredHasProductIdentifierExemption : 1
UnspscCode : 44103100